For information on Heaters and Fireplaces see below
New and replacement freestanding and inbuilt heaters require a Building Consent. The installation must be checked and approved by a Building Officer BEFORE the first fire is lit.
The Ministry for the Environment has regulations that must be followed in regards to the control of emissions and the efficiency of all types of solid fuel burning appliances. Solid fuel heaters and fireplaces are the main cause of domestic air pollution in most New Zealand towns and cities. Design standards assist in limiting emissions of harmful pollutants such as carbon monoxide, volatile organic compounds, hydrocarbons, toxins, and dioxins. The standards apply to all new solid fuel heaters installed in urban areas.
Make sure that the appliance you choose complies with the National Environmental Standards for Air Quality Regulations 2004. The National list of authorised wood burners is available from the Ministry for the Environment website. If the heater you want is not on that list, obtain a test certificate that shows the heater complies with the building standards AS / NZS 4012:1999 and AS / NZS 4013:1999. Provide this certificate to Council at the time that you submit your application for a building consent.
You are exempt from these regulations if your heater is:
You are still able to install and operate open fires, multi-fuel burners, pellet fires, and wood or coal stoves unless the District Plan of your local Council prevents this. Further information can be found on the Ministry for the Environment website.
Make sure that you have
Checked the flue height above the roof is indicated and that it meets the height requirements set out in AS / NZS 2918:2001 Domestic solid fuel burning appliances – Installation
Once the Building Consent has been issued, you will need to arrange for an inspection of the existing fireplace BEFORE the new appliance is installed. The Officer will check that
If the current fireplace and chimney are constructed of masonry (brickwork) then the Officer will check its double thickness, unless otherwise specified by the manufacturer. The fireplace must NOT be used until an Officer checks it meets all the requirements.
Free Standing Heaters
Once the Building Consent has been issued, and the heater installed, you will need to arrange an inspection of the new heating appliance to ensure compliance with the manufacturer’s specifications and the approved plans. This inspection MUST happen prior to the heater being used.
The hearth (the fireproof area directly in front of a fireplace) must provide protection of the floor from the physical hazards of falling embers, as well as downward heat radiation from the appliance. The fixing and materials of the hearth should be strictly as required by the manufacturer.
The space between the appliance and the wall must take into account both short and long-term temperature effects. The distance may only be reduced if a flue screen or a heat shield is used between the appliance and the wall. Materials for heat screens may include sheet metal, bricks, suitable mineral board or a test combination of these three. There must be a gap at the top and bottom of the shield to allow air to circulate behind it. Please check the manufacturer’s specifications.
The main flue and flue shields passing through the ceiling and floor must be clear of all ceiling and roof timbers. Structural members (for example beams, rafters or trusses) must NOT be cut to allow penetration of the flue or flue shields.
Inbuilt and free standing heaters must be secured to prevent seismic movement (earthquake). To achieve this it is recommended that the heater is bolted to the hearth or to the fireplace base.
If the heater has a wetback which is to be connected to a hot water system you are required to have the work carried out by a registered craftsman plumber. Check that the existing or new cylinder is suitable for connection with a wetback, has a tempering valve fitted and is open vented.
No matter how minor the work carried out on a dwelling if it requires a Building Consent the whole dwelling must be upgraded with smoke detectors in order to comply with the Building Code. Smoke detectors must be located:
Smoke alarms are to be installed on or near the ceiling, in accordance with the manufacturer’s instructions. The smoke detectors may be battery powered and are not required to be interconnected. In addition, they must provide a hush facility with a minimum duration of 60 seconds.
Insist on a fully-tested model.